Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

configuring the management port in SupV

Can anyone let me know how to configure the management port present in SupV.

The interface does not seem to exisit when i do a show run.

is there any cisco doc to which someone can point me too

thanks

3 REPLIES
New Member

Re: configuring the management port in SupV

Hi,

The management port is used for IOS recovery. This port will only be active in ROMMON mode.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78_16727.html#wp100588

Please rate if this info was helpful.

Thanks

Deepinder Singh Babbar

New Member

Re: configuring the management port in SupV

Thanks for the info

But the link does not give any information about using the port in case of disaster

New Member

Re: configuring the management port in SupV

Check the below mentioned link that will help u in configuring MGMT Port in case of disaster.

http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_example09186a0080094ecf.shtml#image

Please Rate if info was helpful.

Thanks

Deepinder Singh Babbar

214
Views
4
Helpful
3
Replies
CreatePlease to create content