Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring the router

hi,

what is basic configuration for the router ?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: configuring the router

Hi Ajay,

the basic configuration of Router or a Cisco running IOS or CatOS is setting up the Telnet Password,Enable Password & the IP address for managing the device.

3 REPLIES

Re: configuring the router

Hi Ajay,

the basic configuration of Router or a Cisco running IOS or CatOS is setting up the Telnet Password,Enable Password & the IP address for managing the device.

New Member

Re: configuring the router

hi,

thanks for ur answer and can i know the procedure to configure ?

Re: configuring the router

ITz simply for a basic configuration, find the configuration below, b4 that you u need to connect the console cable between ur PC(on the serial port(com port) & the console port(located mostly back side of the Router/Switch), then change the Com port settingz in the Hyper Terminal in ur PC.

Bits Per second : 9600

Data bits : 8

Parity : None

Stop bits : 1

Flow control : None

then once ur done, then you will take in the Router/Switch Prompt, then go head with the configuration

eg.

router>enable

router#configure terminal

router(config)#line vty 0 4

router(config-line)#password

router(config-line)#login

router(config-line)exit

router(config)#enable secret

router(config)#interface ethernet 0

router(config-if)#ip address 192.168.1.1 255.255.255.0

router(config-if)#exit or press Ctrl+Z

router#

now u have done the basic configuration & juz plug in the router in to ur network & start login.

where line vty 0 4 is the telnet interface

183
Views
3
Helpful
3
Replies
CreatePlease to create content