Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring Vlan

Hi,

I have created few Vlans in my switch (Layer 3). when i give show ip interface brief, some vlans are showing NVRAM (under Method) and some are showing as Manual. Can anyone tell me what is the difference between them. I hv attached the command output also.

Thanks

Kiran

1 REPLY
New Member

Re: Configuring Vlan

Hi,

I gave it a try with a Catalyst 2950.

There are 2 ways to create a VLAN:

- in configuration-mode: (config) vlan x

- in vlan-database-mode: (vlan) vlan x name y

The conifg-file is stored in NVRAM and the VLANs created in the config-file are show as 'NVRAM'.

When creating new VLANs they are first shown as 'manual' - after rebooting the switch they are shown as 'NVRAM'.

207
Views
0
Helpful
1
Replies
CreatePlease login to create content