Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring VLANs on SLM2008

Afternoon Everybody,

I'm trying to place an SLM2008 between 2 switches, ie..

Internet<------>Core<---->24portSwitch1<--->SLM2008<----->24portSwitch2<----->More LAN

What I want to do on the SLM2008:

Port 1 = Trunk (pass all vlans/data)

Ports 2 & 3 = VLAN 1 (for management and a wireless AP)

Ports 4 - 7 = VLAN 8 (incase we need to connect a staff PC, must be able to send/receive DHCP)

Port 8 = Trunk (pass all vlans/data)

I've beat my head around this long enough and have gotten close results, here's whats happening:

  • 24portSwitch1 works perfectly (it should it is infront of the SLM2008)
  • 24portSwitch2 works perfectly (indicates that I have Ports 1 & 8 on the SLM2008 configured correctly)
  • Ports 2 & 3 on the SLM2008 work as intended (management PC connects, Wireless AP works and PC gets DHCP IP)
  • Ports 4 - 7 on the SLM2008, no matter how I configure them, refuse to get DHCP. Hard coding an IP in the VLAN 8 range on the PC does not work either.
  • If I change any of the configuration of ports 1 and 8 it causes 24portSwitch2 to not work.

See attached file and screen shots for more clarification.

Thank you for your time and effort. 30yrs doing this type of stuff and I get hung by a point&click interface!! hahahaha.

Everyone's tags (3)
1161
Views
0
Helpful
0
Replies
CreatePlease to create content