Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring WS-C2950C-24

WS-C2950C-24 IOS V12.1(20)EA1. I am trying to configure the vlan to no ip redirects and no proxy-arp with no success. I have tried configuring these settings under interface w/o success either. Does this IOS version not recognize these settings?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Configuring WS-C2950C-24

Hi,

these options are available in version 12.1(22)EA9 onward.

If you upgrade to this or higher you should be able to use all these. I have following in my configuration

no ip redirects

no ip unreacheables

no ip proxy-arp

no ip route-cache

HTH

Shaheen

4 REPLIES
Purple

Re: Configuring WS-C2950C-24

Those are layer 3 functions , the 2950 is a layer 2 switch . the svi is used to manage the switch only .

New Member

Re: Configuring WS-C2950C-24

Thank you very much,

Ken

Re: Configuring WS-C2950C-24

Hi,

these options are available in version 12.1(22)EA9 onward.

If you upgrade to this or higher you should be able to use all these. I have following in my configuration

no ip redirects

no ip unreacheables

no ip proxy-arp

no ip route-cache

HTH

Shaheen

New Member

Re: Configuring WS-C2950C-24

Thanks Shaheen. So these settings are available in the IOS version 12.1(22)EA9 and later. Do you know is this documented anywhere on the Cisco website?

This is interesting because we just set these variables in a WS-C2962G-24TC-L switch that the CNA identifies as a layer 2 switch also. That switch has version 12.2(25)SEE2 installed.

Ken

152
Views
0
Helpful
4
Replies