02-20-2012 08:43 AM - edited 03-07-2019 05:03 AM
I am trying to find a way using CLI that I can identify the amperage being used by a 6509 chassis. I have looked through all of the sh power and sh env commands and seem to only find the power being used on the DC side (since the output referemces 42V). Ddint know if there was something I was overlooking. To each things from the AC side will take getting an electrician in which is what I was hoping not to have to do.
Ron
02-23-2012 01:14 PM
I doubt if there is anything like that on the CLI.
I would draw you to the following link to help you calculate how much power your 6500 is drawing.
02-23-2012 01:20 PM
Try the command....
show power used
Mike
02-23-2012 01:23 PM
or if it is running VSS then try
show power switch 1
show power switch 2
Mike
02-23-2012 01:26 PM
ooop! sorry should have read the post more carefully....you tried that already.
Mike
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: