03-05-2014 07:56 AM - edited 03-07-2019 06:32 PM
Hi All,
Is there a way to confirm the cli commands inputted into a Nexus5k (NX-OS) Ver 4.1(3) N1(1), before copying it to start. The JunOS has a "commit check" command that will give a heads up if the commands you are about to put in are going to hose your network. The "checkpoint" function will get me back to an operational state, but, I would rather not have to dance while the network comes back to life.
Thanks All,
Ron Clifford
Solved! Go to Solution.
03-05-2014 09:46 AM
Hello
Cisco also have a rollback back feature.This is initiated using the archive command
Once setup it will rollback any applied config if it isn't confirmed within a specified time period- I personally think it better than a schedule reload
However on certain iOS and hardware eg 6509-6513's iI have found it seems to not work as it should also am not aware of any cisco feature that will test your config is good prior to implementing as junos does.
Res
Paul
Sent from Cisco Technical Support iPad App
03-05-2014 10:24 AM
Hi,
IOS-XR implements the commit feature and checks the validity of the config and it seems NX-OS does the same
Regards
Alain
Don't forget to rate helpful posts.
03-05-2014 10:35 AM
Hi Ron,
unfortunately, commit check, rollback 1,2, 3, etc... are all part of Junos and not IOS or Nexus OS. With Nexus OS, as soon as you type a command and press enter, it will take effect just like the regular IOS.
Cisco is trying to add great features that Juniper has, but they still have a long way to go, because they have too many different OSs.
HTH
03-05-2014 09:46 AM
Hello
Cisco also have a rollback back feature.This is initiated using the archive command
Once setup it will rollback any applied config if it isn't confirmed within a specified time period- I personally think it better than a schedule reload
However on certain iOS and hardware eg 6509-6513's iI have found it seems to not work as it should also am not aware of any cisco feature that will test your config is good prior to implementing as junos does.
Res
Paul
Sent from Cisco Technical Support iPad App
03-05-2014 10:24 AM
Hi,
IOS-XR implements the commit feature and checks the validity of the config and it seems NX-OS does the same
Regards
Alain
Don't forget to rate helpful posts.
03-05-2014 10:35 AM
Hi Ron,
unfortunately, commit check, rollback 1,2, 3, etc... are all part of Junos and not IOS or Nexus OS. With Nexus OS, as soon as you type a command and press enter, it will take effect just like the regular IOS.
Cisco is trying to add great features that Juniper has, but they still have a long way to go, because they have too many different OSs.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: