Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Confirming "erase" procedures on 4507

Hi, if I need to clear all configuration on my 4507 (but leave the existing IOS on flash OK, I am planning to get to console on each supervisor and do:

Switch#write erase

then reload it.

Is that all or anything special I need to do when dealing with the supervisor engine?

4 REPLIES
Purple

Re: Confirming "erase" procedures on 4507

That will wipe out any config minus anything that is in the vlan.dat file .

New Member

Re: Confirming "erase" procedures on 4507

I did 'write erase' and I see that vlan information was wiped out. I just see a vlan 20 and obviously vlan 1.

Purple

Re: Confirming "erase" procedures on 4507

Right if it had wiped out everything you would not see a vlan 20 . The main config is wiped out but the vlan info in the vlan.dat is there . I would just manually get rid of vlan 20 .

conf t

no vlan 20

New Member

Re: Confirming "erase" procedures on 4507

Actually that may not be correct. It sounds vlan got wiped out by configuration on the first supervisor...

Thanks.

355
Views
0
Helpful
4
Replies