Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Confirming this output means I have no media on interface?

Folks, if I see on 'show int status'the info pasted below, it means I have no media (fiber or copper port) to plug my cable into this g0/1 switchport, right?

switch#show int status

Name Status Vlan Duplex Speed Type

gi0/1 notconnect 1 auto auto uknown

Device:2950G

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Confirming this output means I have no media on interface?

Hello Marlon,

it could mean the switch cannot recognize the GBIC module or that no Gbic module is inserted.

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: Confirming this output means I have no media on interface?

Hello Marlon,

it could mean the switch cannot recognize the GBIC module or that no Gbic module is inserted.

Hope to help

Giuseppe

Hall of Fame Super Gold

Re: Confirming this output means I have no media on interface?

... or your GBIC could either be faulty or not supported possibly because it's not Cisco (3rd party).

133
Views
0
Helpful
2
Replies
CreatePlease to create content