I would like to connect the LAN?s of 2 location with each other. the provider deliver a gigabit Ethernet between location A and location B. I have in the first location a Catalyst 6000 and in the second location a catalyst 3750G. Is there a document for this example ? what I must follow ?
You have to configure intervlan routing on 3650 switch in new building. So on whichever 3750 you want to have intervlan routing make sure you first create all vlans at layer 2 which are in new building as well as old building.
Like vlan 20,30,40,etc etc should be created forst on that 3750.
Once you are done just configure layer 3 interfaces for all those vlans something like
interface vlan 20
interface vlan 30
and in same way for all vlans for which you want inter vlan routing and then assign respective clients in their vlan the gateway ip address what you will configure on all layer 3 interfaces.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.