Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connect a 10Gb X2 and a TwinGig X2 to same supervisor WS-X45-SUP6-E?

Hi,

We would like to connect a 10Gb X2 and a TwinGig X2 to the same Supervisor (WS-X45-SUP6-E) is this possible. The release note are a little vague.

thanks

Andreas

3 REPLIES
VIP Super Bronze

Re: Connect a 10Gb X2 and a TwinGig X2 to same supervisor WS-X45

Hi Andreas,

According to the datasheet you can do 10Gig or 1Gig (using the TwinGig) on either slot.  So yes, you should be able to do 1 10Gig and 2 1Gigs.

Here is more info:

http://www.cisco.com/en/US/prod/collateral/modules/ps2797/ps9294/product_data_sheet0900aecd806df543.html

HTH

Reza

New Member

Re: Connect a 10Gb X2 and a TwinGig X2 to same supervisor WS-X45

Hi Reza,

Thanks for the reply.

I also have that datasheet but there seems to be conflicting documents if you see below:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/configuration/guide/sw_int.html#wp1084402

This says there is a limitation.

So im having trouble to to clarify this and i dont have the equipment to test this.

thanks

Andreas

VIP Super Bronze

Re: Connect a 10Gb X2 and a TwinGig X2 to same supervisor WS-X45

Hi Andreas,

After reading the link you posted, it seems that you can only do 10Gigs or 1Gigs and not a mix of both, but than again to be sure, it needs to be test it.

Thanks,

Reza

210
Views
0
Helpful
3
Replies