Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connect a 2950 with Accelar 1050

Hi to all. I'm try to connect a Catalyst 6509 with a accelar 1050. In the Catalyst the interface has "Trunk Encapsulation dot1q" because this is a trunk interface, but I don't know how configure it in the accelar. Somebady has done this configuration and can help me? Or can help me in another way.

Thanks a lot.

Francisco Velasco

2 REPLIES
New Member

Re: Connect a 2950 with Accelar 1050

Francisco-

As far as I can remember, the 1050 doesn't support VLANs, so you wouldn't need trunking on the Accelar, and you could remove that statement from the Cisco uplink port. VLAN 1 info will still be available on the Accelar.

HTH,

Paul

New Member

Re: Connect a 2950 with Accelar 1050

OK Paul. I appreciate your help. That's correct your opinion, I going to do your suggest. Thanks again.

113
Views
0
Helpful
2
Replies