I am guessing that this is a simple solution, but for some reason I am not searching the correct terms.
I have a consumer grade wifi/gig ethernet router (Netgear r7000) and I need to configure my Cisco Catalyst 3560 to connect to the router in order to allow internet access to all connected computers on the switch.
Netgear Router (r7000): 192.168.1.1 255.255.255.0
Default Gateway 192.168.1.1
Cisco 3560 Vlan1: 192.168.1.250 255.255.255.0
How do I configure a port to act as an "uplink" to the router? Thanks in advance!
You really shouldn't have to do anything special. Your router will be in vlan 1 along all of your other devices on the 192.168.1.0/24 subnet. Just connect your Netgear to port 1, for example, and you should see a link come up. If you don't see the link come up, try using a crossover cable (although I highly doubt this will be needed). There isn't a special uplink port like you see in soho switches you'd pick up at Best Buy.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...