Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

connect directly to a VTY greater than 0-4

Hi all.

 

Is there a possibility to connect directly to a specific vty via Telnet or ssh?

The fact is: I have a misconfigured switch with no athentication on line vty 0 4, but with the correct configuration on vty 5-15.

 

So I would like to know if there is a possibility to specify the linie vty I'll connect.

 

Thanks for your help.

Best regards

Markus

2 REPLIES
Silver

I don't know if it is

I don't know if it is possible but why don't you try to open 5 telnet so that the firs 4 vty are busy and the fifth will use one of the other ?

 

Bye,

e

Hall of Fame Super Silver

I agree with e's approach. I

I agree with e's approach. I don't believe you can initiate a connection to a specified vty line - IOS will always use the next available open line..

You'll need to launch SIX simultaneous connections. The first five will hit vty 0-4 (five lines) and the sixth should be to vty 5.

You could also use console. :)

 

49
Views
0
Helpful
2
Replies
CreatePlease to create content