Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting 2 different domains, same physical location

We have 2 separate networks, each with a different domain. Each network's domain

controllers and servers are in the same physical location. Each network/domain has

its own router and public address. If I connect a port on a switch on one of the

networks (192.168.10.X) with a port on a switch used on the other network

(192.168.150.X), that is behind the router and firewall connections, will the

different networks be able to communicate with each other? (ping, shared folders,

etc.) If I set up a trust relationship between my 2 networks, so that they have the

same forest, would my switch to switch connection work then?

5 REPLIES
Blue

Re: Connecting 2 different domains, same physical location

Richard:

From the perspective of inter-subnet/vlan routing, to be able to pass traffic between two vlans, you will need a router.

If the two subnets belong to the same vlan, then hosts on each subnet will be able to communicate amongst themselves using layer-2/MAC addresses.

Example:

Vlan 10

ip address range: 10.10.0.0/23 gives you two subnets.

10.10.0.0/24

10.10.1.0/24.

Hosts on each of these subnets will be able to communicate with each other without the need for a routing engine because they belong to the same vlan. If they didn't, that is when you would need a router/L3 switch for inter-vlan routing.

HTH

Victor

New Member

Re: Connecting 2 different domains, same physical location

Thanks Victor. We will try that, and I will post if we were successful.

Blue

Re: Connecting 2 different domains, same physical location

I'm sure you will be if you follow that paradigm.

Good luck!

New Member

Re: Connecting 2 different domains, same physical location

You were right, we were able to set this up by changing the 2 domain controllers that we wanted to connect by changing the subnet mask to 255.255.0.0. Then we were able to setup the trusts between them. Thanks for your help!

Blue

Re: Connecting 2 different domains, same physical location

You're welcome. Now dont forget to give me all my ratings. :-D

Victor

296
Views
0
Helpful
5
Replies