Connecting a Hawking HOWABN1 Access Point to Cisco 3560 Switch

[mconway]

I'm having issues connection a Hawking access point to a Cisco 3560 switch.

I am unable to ping the access point from the switch CLI.

The interface config looks like this: (interface where AP is connected to)

interface GigabitEthernet0/15

switchport trunk encapsulation dot1q

switchport mode trunk

macro description cisco-switch

auto qos voip trust

spanning-tree link-type point-to-point

I also could use some help in designing the topology.  DHCP / VLAN

Currently I have the AP acting as a DHCP Server.   There is also a Windows DHCP Server on the LAN 

AP is 10.0.1.240 / 24

Gateway Address is 10.0.1.254 / 24 which is the SVI for VLAN 15

Ideally I would like to set this AP up as follows:

Main SSID would be for LAN and Internet Access

ESSID would by for just Internet Access (Public WiFi) this unit supports VLAN IDs for this.

[juan.elias.gt]

Hi, your problem is in the native-vlan, for defect HOWABN1 set default vlan as administrative vlan. Talking about another topic i have a doudt, what´s amount of bandwith should have during a file transfer? I have troubles with it.