Cisco Support Community
Community Member

Connecting a Hawking HOWABN1 Access Point to Cisco 3560 Switch

I'm having issues connection a Hawking access point to a Cisco 3560 switch.

I am unable to ping the access point from the switch CLI.

The interface config looks like this: (interface where AP is connected to)

interface GigabitEthernet0/15

switchport trunk encapsulation dot1q

switchport mode trunk

macro description cisco-switch

auto qos voip trust

spanning-tree link-type point-to-point

I also could use some help in designing the topology.  DHCP / VLAN

Currently I have the AP acting as a DHCP Server.   There is also a Windows DHCP Server on the LAN 

AP is / 24

Gateway Address is / 24 which is the SVI for VLAN 15

Ideally I would like to set this AP up as follows:

Main SSID would be for LAN and Internet Access

ESSID would by for just Internet Access (Public WiFi) this unit supports VLAN IDs for this.

Community Member

Hi, your problem are in the

Hi, your problem is in the native-vlan, for defect HOWABN1 set default vlan as administrative vlan. Talking about another topic i have a doudt, what´s amount of bandwith should have during a file transfer? I have troubles with it.

CreatePlease to create content