Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting a wireless router to a wired router

I have a Linksys/Cisco BEFSR81 cable/DSL router with 8 port switch.  I need to add wireless capability to the system so I can connect up to 11 computers in my home.  Is it possible to attach a Cisco WRT400N dual band wireless N router to one of my ports on the BEFSR81?

If this is possible, would there be anything else I need to do to make this happen.  This will allow all of our computers and laptops to share the internet connection.

Everyone's tags (5)
1 REPLY

Re: Connecting a wireless router to a wired router

Hi there,

You should be fine.

I would set a static ip address on the wireless router with a default gateway of the DSL modem, you could also hard code the duplex and speed on both sides, because your using a N router which is probably 1000MB and the Cisco DSL modem is most likely 100MB.

HTH, please rate below if so.

Regards,

Justin

1999
Views
0
Helpful
1
Replies