Hi all, if I have 4 floors say with 200 users on, how would i connect thesesay 5 switches together on each floor? stack them, or connect switches to each other and also all of them to one of the switches ?
If the switches are stackable, i.e. 3750 series, stack them, then uplink the stack. If possible, use a multiple member uplink channel so that failure of any one switch in the stack doesn't disconnect the whole stack. (Also assuming the next device upstream is a chassis, and if it supports multiple line card channels, use such, so again failure of an individual line card doesn't disconnect the downstream stack.)
Your best bet will be to star them out from a single switch for easy of troubleshooting . Daisy chaining is a poor option . Not sure what you mean by stack them , are you using 3750"s as those are the only switches that are really stacked.
Yes. "Star"ing them is simply that. You're creating "hub-and-spoke" topology. Essentially, the "aggregation" switch will become 2nd distribution switch (sounds like you already have one).
If your switches don't stack (i.e. you're NOT running 3750s), then that's your only option. As the other poster said, daisy-chaining is BAD. The only thing worse than daisy-chaining is daisy-chaining using GigaStack!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.