Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connecting service module through the backplan on 3845

I have a 3845 with a 48 port ES , I am able to you use the service-module gig2/0 session I am able to access the card. What I am trying to do is access it through the backplan. My question is shouldn't I be able to configure the card from the router prompt once the card is connected to the backplan, to utilize the backplan speed?

When I do a service-module status on the switch it gives me

lchar02ports\par#sh service-module status

Service Module is in STEADY state

Service Module target interface is GigabitEthernet1/0/4

Interface GigabitEthernet1/0/3 is connected to BACKPLANE

seems to be working ok? when i jump to the router CISCO tells me to connect them using ;router(config)# connect himi module g2/0 0 module g0/0 0 , but the router never give me the module option?

any ideas?

161
Views
0
Helpful
0
Replies