Connecting to an activation server through two switches
I am trying to set up an activation server for a lab. The activation server is looking out to another server and getting its information that way. Therefore I need to connect over the internet. I want to use ICS on the activation server, so I have put two nic cards in it; one going to the internet, which uses ics, and the other is going to a cisco 4948 switch. If I connect another computer directly to this switch, and set its gateway to the ip address of the activation server I can ping out across the internet to the destination server. However, I have switches like the cisco 2950 also connected directly to this 4948 and there are several computers on these switches. I can ping to the activation server, but i cannot ping to the destination server across the internet. Is there some configuration that I have to do to the 4948 or other ways I can get this access?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...