Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting to CDM600

Hello all,

I've been trying to use a Comtech Satellite Modem with a Cisco Router 2600 with a WIC-1T interface, using a CAB-530MT Cable.

I was wondering if anyone had had any experience with it.

Is there special settings for the serial interface so that it works with the modem.

As for the cable, I read somewhere on line that I was supposed to remove the pin 23 on the modem side, to have it working because so far plugging it in stops the modem.

Thanks for the help.

PS Giuslar if you read this I have a question concerning the setup you advised me on for the routing.

Nice days to all

CreatePlease to create content