Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connecting two branches ( one side E1 other side V.35)

Hi all,

    One of my customer place they have 7600 router with E1 SPA card and other  branch they have 2800 router with serial interface. ISP ask me to configure the E1 has unframed and clock is line. Can any body help me out in this.

1 REPLY
Cisco Employee

Re: connecting two branches ( one side E1 other side V.35)

chandru.j wrote:

Hi all,

    One of my customer place they have 7600 router with E1 SPA card and other  branch they have 2800 router with serial interface. ISP ask me to configure the E1 has unframed and clock is line. Can any body help me out in this.

Try this config assuming SPA is installed in sub-slot 0 of a SIP-200 in slot 3 and the E1 is port 0:

!

card type e1 3 0

!

controller E1 3/0/0

  channel-group 0 unframed

!

interface serial 3/0/0:0

  ip address x.x.x.x y.y.y.y

  no shut

!

Atif

206
Views
0
Helpful
1
Replies