I need to use l2 because I need to have same vlans available on both sides. Which ports I put in trunk mode? The one between 3750-E? What about ports between 4506 and 3750-E and between 3750 and 3750-E ? Should I create etherchannel using both fiber?
If you don't use etherchannel, aren't you going to run into STP issues? I'm not an expert, but default properties of spanning tree will disable one of your links. If you do etherchannel, I think you'll basically have a redundant physical connection and twice the bandwidth...
As far as the trunking question, if it is all L2, you're going to need to trunk between all of the links you have in your picture above.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...