Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Connection to 2960-S using USB Console Cable

I am trying to connect to a new switch using the USB Console Cable. I have downloaded and installed the 3.1 drivers from the website.I have also looked at other posts here on how to manually install the driver but that is not my problem. I get an error that the driver is not digitally signed so it won't install. I have attached 2 screen shopts one showing my device manager and one showing the error.Any help would be much appreciated.                  

121
Views
0
Helpful
0
Replies
CreatePlease to create content