Console links state alerts not showing

[sdaniels44]

This is probably an easy question.

When i issue a terminal monitor command on a cat 6500, I am not getting info on link state changes.

ex.

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down

I can not see anything using "debug interface ?" that jumps out as the obvious answer. Any ideas?

Thanks.

[cisco_lad2004]

do u have snmp trap link-status configured under interface ?

SNMP needs to be activated in some cases, like this one.

HTH

Sam

[sdaniels44]

This has to be done for each interface?

[srue · Accepted solution]

see if this link helps:

http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_l1.html#wp1025176

[sdaniels44]

That was it. Thanks for your help.

[srue]

you're welcome..thanks for the points...