Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Console links state alerts not showing

This is probably an easy question.

When i issue a terminal monitor command on a cat 6500, I am not getting info on link state changes.

ex.

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down

I can not see anything using "debug interface ?" that jumps out as the obvious answer. Any ideas?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Console links state alerts not showing

5 REPLIES

Re: Console links state alerts not showing

do u have snmp trap link-status configured under interface ?

SNMP needs to be activated in some cases, like this one.

HTH

Sam

New Member

Re: Console links state alerts not showing

This has to be done for each interface?

Gold

Re: Console links state alerts not showing

New Member

Re: Console links state alerts not showing

That was it. Thanks for your help.

Gold

Re: Console links state alerts not showing

you're welcome..thanks for the points...

187
Views
0
Helpful
5
Replies