We are trying to use the Cisco Configuration Professional. I connected my PC vis USB to USB. Professional could't connect via USB, I got an error ~ can't detect anything in COM1 or COM2. I was able to get hyperterminal to work via USB. Does Professional only connect via the Ethernet connector?
Also, CCP will recognize COM3 (USB Serial) while hyper terminal is connected to the router. But, gives an error that COM3 is already in use and disconnect before using that connection. When I disconnect CCP doesn't recognize the connection any longer.
Thank-you. I'm confused though. When I view the CCP documentation it says I can connect to the console port, and shows a diagram with the PC connected to the RJ45 console port. It also shows that it can connect through a modem attached to the AUX console RJ45 port. The 2900 added a mini USB console port. We downloaded the CISCO serial USB driver and connected a PC through USB to mini-USB and could run hyperterminal. We then used CCP on the same PC but couldn't establish a connection through the USB ports. I'm assuming that CISCO did not add USB interfaces to CCP, and I will need a DB9/RJ45 cable and connect the PC to the RJ45 console port. This make sense?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.