If i do a show clock it shows the correct time. When i see events being logged on the console (IE: a link going up/down) It shows the time as incorrect. It is not applying the correct timezone. Example.
While it is a good thing to do, the service timestamps debug does not relate to the issue that you describe since it controls the timestamps for debug output.
I believe that the answer is in service timestamps log as Mahmood has suggested. And I believe that you probably already have service timestamps log datetime configured, because if you did not the log messages would report uptime rather than clocktime. But I believe that it is not enough to configure service timestamps log datetime. I believe that you need to include the localtime parameter, especially if you are learning time from NTP. So it would be service timestamps log datetime localtime.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.