Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

%CONST_DIAG-SP-3-HM_TEST_FAIL: Module 7 TestMacNotification consecutive failure count:5

Can anyone tell me what this error mssg means, what the severity is, and what the resolution is?

 

%CONST_DIAG-SP-3-HM_TEST_FAIL: Module 7 TestMacNotification consecutive failure count:5

 

Thanks for any feedback.

  • LAN Switching and Routing
1 REPLY
Silver

Hi, See this

Hi,

 

See this:

TestMacNotification Diag Test Error

Problem Symptom:

Following messages may be seen on the console :

*Mar 10 10:25:53.562: %FABRIC_INTF_ASIC-DFC9-4-FABRICCRCERRS: Fabric ASIC 0: 322 Fabric CRC error events in 100ms period
*Mar 10 10:26:31.071: %CONST_DIAG-SP-3-HM_TEST_FAIL: Module 9 TestMacNotification consecutive failure count:5
*Mar 10 10:26:31.071: %CONST_DIAG-SP-6-HM_TEST_SP_INFO: TestMacNotification[9]: last_busy_percent[33%], Tx_Rate[3077], Rx_Rate[1302]

Root Cause :

This TestMacNotification could fail if there is some issue with the bridge ASIC/data path. 
One of the reason could be some corrupted packets enter the bridge asic and cause the memory buffers to get locked up.

Troubleshooting and Recommendation:

1. Check if there any Fabric CRC errors *"*FABRICCRCERRS" in the logs.

    If there are Fabric CRC errors followed by TestMacNotification test failure then issue could be because of CSCto55567 , upgrade to release 12.2(33)SRE5 or higher.

2. If TestMacNotification test fails without Fabric CRC error then contact the BU, it requires complete data path debugging.

Related DDTS: CSCto55567 

 

Hope this helps.

622
Views
0
Helpful
1
Replies
This widget could not be displayed.