Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Continuous increment of collision/late collision/interface reset

What could be the reason for continuous interface reset

2 REPLIES
Hall of Fame Super Silver

Re: Continuous increment of collision/late collision/interface r

Hello Meenakshi,

if the rate of excessive collisions is high likely the interface outout queue gets full while waiting between successive to transmit current frames.

The router resets the interface that looks like stucked.

late collisions may be the sign of duplex mismatch check on both sides of the links what are the settings

Hope to help

Giuseppe

Purple

Re: Continuous increment of collision/late collision/interface r

There is usually little reason to run a link at half duplex so you should not be getting any collisions unless you have speed/duplex mismatches on each end.

275
Views
0
Helpful
2
Replies
CreatePlease login to create content