Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Control Plane Security Configuration

Hey guys, I was looking for some advice about configuring the control plane to mitigate DoS attacks. I understand you can use

MQC and apply it inbound and or outbound to the control plane, I just couldn't find any examples of configuring it to prevent and

mitigate DoS attacks. Or some recommended practices for this sort of thing. Like the recomended setting for policing TCP etc.

I know this depends on someone's specific setup, but was just looking for a pointer or two.

Everyone's tags (4)
3 REPLIES
VIP Purple

Control Plane Security Configuration

Control Plane Security Configuration

JohnTylerPearce wrote:

Hey guys, I was looking for some advice about configuring the control plane to mitigate DoS attacks. I understand you can use

MQC and apply it inbound and or outbound to the control plane, I just couldn't find any examples of configuring it to prevent and

mitigate DoS attacks. Or some recommended practices for this sort of thing. Like the recomended setting for policing TCP etc.

I know this depends on someone's specific setup, but was just looking for a pointer or two.

Hello ,

Check out the below link which basically talks about control plane security ....

http://www.cisco.com/en/US/docs/ios/sec_control_plane/configuration/guide/sec_control_plane_overview.pdf

Hope to Help !!

Ganeshh Iyer

Rate if it Helps...

Control Plane Security Configuration

Thanks for the help guys.

384
Views
6
Helpful
3
Replies
CreatePlease to create content