Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

converting catos to IOS

Does anyone know/has where I can get the steps to convert catos to ios for a 4000 series catalyst.

I searched everywhere no luck so far.

thank you

6 REPLIES
New Member

Re: converting catos to IOS

Check this link

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml.

Just did this last night on a 6500 with Sup32.

New Member

Re: converting catos to IOS

thank you for your reply.

is the conversion for 4000 series the same as in 6500 MSCF?

thank you.

Purple

Re: converting catos to IOS

You cannot change a 4000 switch to IOS . You must have at least a Sup II plus supervisor to run IOS which it comes with . No catos conversion for the older 4006 series with a Sup 2 .

New Member

Re: converting catos to IOS

I am working with a Catalyst 4003 series.

Model: WS-C4003

supervisor engine WS-X4012.

Purple

Re: converting catos to IOS

Can't do it with that thats even older than a Sup II . Catos only for that model . Only the newer sup's from Sup II plus up to Sup V run IOS and those ship from the factory with IOS. Earlier versions like yours cannot be converted.

New Member

Re: converting catos to IOS

Glean,

Thank you for your replies. I appreciate your help.

149
Views
0
Helpful
6
Replies
CreatePlease login to create content