Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Converting from CatOS to IOS on cat6500

I converted my switch to the IOS successfully. For some reason my msfc is now missing, what did I do wrong? When I do issue the sh module command, I am missing the module 15. Please advise.

3 REPLIES
Community Member

Re: Converting from CatOS to IOS on cat6500

Please see this link. It contains some good information. I used it for a similar situation this AM on a test switch.

http://www.cisco.com/en/US/partner/products/hw/switches/ps700/products_tech_note09186a008015bfa9.shtml

Tim

Silver

Re: Converting from CatOS to IOS on cat6500

Hi,

the "sh mod" output is slightly different in the (native) IOS as compared to hybrid (ie.CatOS). There is no module 15 construct within IOS. You should see your msfc however under submodule display. E.g. you see your supervisor within the modules part of the output in position 5 and beneath under the submodules part of the output you should see both the msfc and pfc as submodules (as submodules for the module in position 5). I hope my English makes sense.

Best regards,

Antonin

Community Member

Re: Converting from CatOS to IOS on cat6500

I don't remember seeing any submodules under the mod 5. I will verify next time I go to the lab. Will the msfc be accessible? and how? Thank you.

182
Views
0
Helpful
3
Replies
CreatePlease to create content