Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Copied configuration, what next

I'm trying to add a new Catalyst c3550 series switch to our stack. I'm a newbie and I'm sure how the network is setup, so to save myself the stress of having to figure out how to configure the switch, I copied the configuration of one the working switches to the new one. The problem is, it doesn't work. I can't connect to the internal network (which is on a Vlan). Does anyone have any ideas what I should do next?

1 REPLY
New Member

Re: Copied configuration, what next

copying the config is good...but you just cant copy everything.

you will need a new IP address and also better to have a new hostname.

and also if you have set up vlans (other than default) you will have to set those up accordingly.

93
Views
0
Helpful
1
Replies