I'm trying to add a new Catalyst c3550 series switch to our stack. I'm a newbie and I'm sure how the network is setup, so to save myself the stress of having to figure out how to configure the switch, I copied the configuration of one the working switches to the new one. The problem is, it doesn't work. I can't connect to the internal network (which is on a Vlan). Does anyone have any ideas what I should do next?
copying the config is good...but you just cant copy everything.
you will need a new IP address and also better to have a new hostname.
and also if you have set up vlans (other than default) you will have to set those up accordingly.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
