Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Copy flash:file startup_config booting router to factory default.

hello

having a problem with my router 3845 whenever i am trying to reload with below command  "copy flash:XXX startup-config" it boots up and comes as default configuration mode. it does not load the file configuration saved in XXX. as result its come as dump box and nothing else.

(C3845-ADVENTERPRISE0_IVS-M), version 12.(4)T7, RELEASE SOFTWARE (fc2).

i have checked the boot system its having the correct image and there is no changes have done on the router, Earlier it was working fine.

Any idea ?

Regards

Rajeev

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Copy flash:file startup_config booting router to factory default

hello Rajeev,

Can you please post the router current config and post the show ver from the  command line.

Also check what is the confreg value under

router(boot)>show version  
!-- This will be 0x2102 at the next reload. >>>>>>>>>> Ideally it should be same as defined here.
if not then change it.


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.
3 REPLIES
Cisco Employee

Copy flash:file startup_config booting router to factory default

hello Rajeev,

Can you please post the router current config and post the show ver from the  command line.

Also check what is the confreg value under

router(boot)>show version  
!-- This will be 0x2102 at the next reload. >>>>>>>>>> Ideally it should be same as defined here.
if not then change it.


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.
Cisco Employee

Copy flash:file startup_config booting router to factory default

just add one more thing to change the value, you need to go to global config mode

# config-register 0x2102

then save the configuration and try to load configuration and check if its working fine or not.


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.
New Member

Copy flash:file startup_config booting router to factory default

Yes, it showed as 0x2142 and changed the same now its working as earlier .Thanks for prompt response appreciate

Regards

Rajeev

114
Views
5
Helpful
3
Replies
CreatePlease to create content