05-20-2009 10:25 PM - edited 03-06-2019 05:51 AM
Dear experts,
Is there a way to copy one port config to other port ? i mean seemthing like "copy port X to port Y".. That way the machine will copy the whole config of port X one by one to port Y.
Thanks,
Yosi :)
05-21-2009 02:19 AM
Yosi
You could look into smartport macros which allow you to apply a standard configuration across multiple ports -
Another option is to use the interface range command eg.
switch(config)# interface range fa0/1 - 10
switch(config-if-range)#
then any commands you type in apply to all ports in the range fa0/1 - 10.
Finally there is good old cut and paste at the CLI prompt.
Jon
05-21-2009 02:38 PM
Hi Yosi,
Jon's right. I'm using macro and it's alot faster and more accurate than cut-n-paste.
macro apply
Hope this helps. Please rate when applicable.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: