Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Correct cable for

Hello Experts!

I am looking for the cable and baud rate for connecting to WS-SUP32-10GE-3B module. On the Cisco website (http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Chassis_Installation/Cat6500/03instal.pdf) it says that sup module for 6513 uses a rollover cable at 9600 8 none 1. However,this did not work with my current sup32 module. Does anyone have a suggestion?

Thanx

2 REPLIES
New Member

Re: Correct cable for

Computers usually have a DB-9 serial port are you sure the adapter you are using has the correct pinouts. If you have any doubts the standard one piece console cable used for other cisco devices should work.

New Member

Re: Correct cable for

Thanks for your input. Issue was the standard one piece console cable was bad. I replaced it with a db9 connector and rollover cable and was able to connect.

114
Views
0
Helpful
2
Replies