11-24-2013 11:29 PM - edited 03-07-2019 04:46 PM
dear all,
i have C3750X with IOS 15.0(2)SE2 license ipservices, and cisco WSA (Ironport S170).
i tried to configure transparent proxy using WCCP on the 3750 but eventually the traffic couldnt redirect to the 3750.
my configuration is just like this :
a. 3750
notes : 172.20.165.37 is my client who want connect to the internet through WSA
!
interface GigabitEthernet1/0/39
description ## LINK TO PROXY (IRONPORT WSA)
no switchport
ip address 172.20.160.34 255.255.255.252
!
ip wccp source-interface GigabitEthernet1/0/39
ip wccp web-cache redirect-list testing2
!
ip access-list extended testing2
permit ip host 172.20.165.37 any
!
interface Vlan165
description ## Data 12 Floor ##
ip address 172.20.165.254 255.255.255.0
ip helper-address 190.191.11.1
ip wccp web-cache redirect in
b. WSA configuration
the picture of my configuration is on the attachment
when i execute the command "show ip wccp", it shows just like this
Permata_11F_CSW1#sh ip wccp
Global WCCP information:
Router information:
Router Identifier: 172.20.160.34
Configured source-interface: GigabitEthernet1/0/39
Protocol Version: 2.0
Service Identifier: web-cache
Number of Service Group Clients: 0
Number of Service Group Routers: 0
Total Packets Redirected: 0
Process: 0
CEF: 0
Service mode: Open
Service Access-list: -none-
Total Packets Dropped Closed: 0
Redirect access-list: testing2
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: -none-
Total Messages Denied to Group: 0
Total Authentication failures: 0
Total GRE Bypassed Packets Received: 0
Process: 0
CEF: 0
the packet seems not redirect to the 3750
could anyone help me to solve this issue? really appreciate your help guys
best regards
-Haris-
11-28-2013 06:16 AM
What router ID did you set on the S170?
Also, did you play with Load-balancing method (MASK/HASHING) settings and the Forwarding / Return method (GRE/L2) in the advanced tab?
Also provide the output of "sh ip wccp xx detail" command
I have the samme problem, but at least I have 1 Service group
sh ip wccp 100
Global WCCP information:
Router information:
Router Identifier: 10.101.241.61
Protocol Version: 2.0
Service Identifier: 100
Number of Service Group Clients: 1
Number of Service Group Routers: 1
Total Packets s/w Redirected: 0
Process: 0
CEF: 0
Redirect access-list: 99
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: -none-
Total Messages Denied to Group: 0
Total Authentication failures: 0
Total Bypassed Packets Received: 0
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: