Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

couldn't clear monitor session from my 6500

I tried to clear monitor session on 6500 and keep on getting the following error:

%Another session parameters or permit-list is being configured

%Please wait for another configuration to complete.

Please let me how i can go about clearing the monitor session.

Thanks

Kerim

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

couldn't clear monitor session from my 6500

Hello Abdul,

Please try the below in the switch,

switch#test monitor clear config lock

This should be implemented on RP side which sets the semaphore to FALSE. Since the command tampers with the semaphore which might have been hold by an another console/telnet session.

Let me know how this goes.

Thanks,

Ricky Micky

*Rate useful posts

1 REPLY
Cisco Employee

couldn't clear monitor session from my 6500

Hello Abdul,

Please try the below in the switch,

switch#test monitor clear config lock

This should be implemented on RP side which sets the semaphore to FALSE. Since the command tampers with the semaphore which might have been hold by an another console/telnet session.

Let me know how this goes.

Thanks,

Ricky Micky

*Rate useful posts

426
Views
0
Helpful
1
Replies
CreatePlease login to create content