CRC count from a c7200 VPN box to a 2912-xl switch
So let's see.
I have two VPN routers that are connected to two seperate Switches for failover.
I'm getting CRC erros on the switchport that the router is plugged into (no matter what port I plug it into) I've verified duplex and speed, I've also changed the cable out. Doesn't matter what port I plug the router into the crc's start to count up. No crc's on the routers interface.
Re: CRC count from a c7200 VPN box to a 2912-xl switch
Just updated the switch last night. There are other devices using the switch without any problems at all. Even when the router is in standby mode there are no CRC's on the switchport it's plugged into. It seems that only the VPN traffic causes it. Doesn't make any sense to me, but I thought that maybe because all the switchports are in a vlan it might have something to do with how the Gig interface on the router is configured. Do I need to encasuplate dot1q on that interface going to the switch? Also this happens on both my outside switches, I don't see how both switches can be bad.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...