Cross-stack Etherchannel in the 12.2.(40)SE IOS Release
There is stack of two Catalyst 3750E-24T and of two Catalyst 3750E-12S. On the two Catalyst 3750E-24T configured Cross-stack Etherchannel (interface Port-channel1) is bundling interfaces GigabitEthernet 1/0/1 and GigabitEthernet 2/0/1 in the mode 'on'. This Port-channel connected to Port-channel on Catalyst 2960 (interface Port-channel1) which is bundling Interfaces GigabitEthernet 0/1 and GigabitEthernet 0/2 in the mode 'on' too. I have next result:
Re: Cross-stack Etherchannel in the 12.2.(40)SE IOS Release
The latter two commands you're doing look a little more in-depth into the switch asic programming. These commands often dont have cross-switch visibility, which is why you're only seeing information that pertains to the switch you're on.
For the other half of the information try this:
remote command 2 show etherchannel 1 port
remote command 2 show etherchannel 1 port-channel
remote command all show etherchannel 1 port
remote command all show etherchannel 1 port-channel
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.