Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

crossover - straight through cable question

can someone tell me the command syntax to allow a switch port to "auto sense" or electronically re-orientate pin outs between a crossover and a straight through cable? Thanks, peter@it-123.co.uk

3 REPLIES
New Member

Re: crossover - straight through cable question

"The Auto-MDIX feature is enabled by default on switches running Cisco IOS

Release 12.2(1SE or later. For releases between Cisco IOS Release 12.1

(14)EA1 and 12.2(1SE, the Auto-MDIX feature is disabled by default. For

configuration information for this feature, refer to the switch software

configuration guide or the switch command reference"

I copied and pasted this from a posting from another site! HTH

Purple

Re: crossover - straight through cable question

This is only available on the newer switches and routers , the older stuff like 2950,3550's do not support this.

New Member

Re: crossover - straight through cable question

thanks for this

134
Views
0
Helpful
3
Replies