I am running a Catalyst 3560 PoE. Trying to setup SSH for remote logon. I understand that in order to do this I need to setup a Crypto key, but there is no crypto command. All ideas are appreciated. Thanks
Just found this article:
Configuring the Switch for Secure Shell
This section describes how to configure the Secure Shell (SSH) feature. To use this feature, you must install the cryptographic (encrypted) software image on your switch. You must obtain authorization to use this feature and to download the cryptographic software files from Cisco.com. For more information, see the release notes for this release.
Advanced IP services is a whole new feature set whereas all you need is the same feature set you have with the crypto bit. So you have
and you need
Most crypto versions will have a K9 in the image name somewhere although I remember the 2950's did not have a k9 in the image , usually it does .