I recently added an SDFlash memory to an IE2000 switch. In event of a switch failure, I can just the SD memory card into the new one. Both IOS and configuration is working correctly and tested. I noticed that the crypto key that was created for using SSH was not working. I created a new one by issuing a "crypto key generate rsa" and created 1024 bit modulus. It's been verified and works however, after reloading the switch, it is not saving the mypublic rsa key.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...