Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ctrl + Break sequence not working

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Ctrl + Break sequence not working

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

Hi,

Check out the below link for password recovery on cisco switches series

http://www-tss.cisco.com/eservice/compass/common/activities/password_cat_2950.htm

HTH

Ganesh.H

2 REPLIES

Re: Ctrl + Break sequence not working

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

Hi,

Check out the below link for password recovery on cisco switches series

http://www-tss.cisco.com/eservice/compass/common/activities/password_cat_2950.htm

HTH

Ganesh.H

New Member

Re: Ctrl + Break sequence not working

Thanks, that did the trick. I guess the break key sequence was disabled on this switch? Something I'll have to look into -- I know the key sequence can be disabled on a router.

1639
Views
0
Helpful
2
Replies