here is the solution, it was so quiet stupid simple....
You've to edit the Wireless or Wired LAN with is setup with a WebAuth. Then you can select under the menu topic "Security" the tap "Layer 3" as shown in attachments. Here you select Web Authentication and also select "Over-ride Global Config". Now you can select for all three paged an individual file.
And that it.
If anybody needs some help or an working full customized WebAuth sample, feel free to contact me.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...