Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Data Trace

Hi,

I have connected two normal cisco switch from cisco 2960 managable switch. The normal switch is connected to interface 0/1 and interface 0/2. I can see the abnormal traffice between these interfaces. The MRTG graph shows maximum bandwidth utilization between these interfaces. Both the interfaces are connected in the same LAN. I don't have got the passwords of the host. Now I want to know which IP is consuming the maximum bandwidth, how can I get this data ?

Regards,

Mero

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Data Trace

Hi Mero,

Can yo configure SPAN session on 2960 to see what packets are sent out interface 0/1,0/2?

HTH,

Lei Tian

1 REPLY
Cisco Employee

Data Trace

Hi Mero,

Can yo configure SPAN session on 2960 to see what packets are sent out interface 0/1,0/2?

HTH,

Lei Tian

106
Views
0
Helpful
1
Replies
CreatePlease to create content