Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DEAD 2940?

Not really dead, but just made the mistake of erasing the flash and NVRAM. Anyways, I am fairly new to networking, and I am trying to load the IOS to the flash. How do I do that? TFTP server? What is the actual, step by step command?

3 REPLIES

Re: DEAD 2940?

Hello,

Is the switch on rommmon mode now? If so, you can use the xmodem commandsets to upload the IOS through the hyperterminal. You have to be on the console of the switch for this. you can then use the command :

xmodem -c imagename 115200

where 115200 is the speed at which the upload will happen..

Refer to this link for more info:

http://cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

Hope this helps.. all the best... rate replies if found useful..

Raj

New Member

Re: DEAD 2940?

Thanks Raj, I think that will work.

Re: DEAD 2940?

Test it and let us know in case of any issues.. if it works, mark the case as solved, which can help others.. rate replies if useful.

Raj

149
Views
0
Helpful
3
Replies
CreatePlease to create content